Lenovo x3530 M4 Installation And Service Manual page 62

To install an adapter, complete the following steps:
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the top cover (see "Removing the server top cover" on page 33).
Step 4. Follow the cabling instructions, if any come with the adapter. Route the adapter cables before
you install the adapter.
Step 5. Installing an adapter in PCI riser-card assembly 1:
Insert the adapter into the PCI riser-card assembly, aligning the edge connector on the adapter with
the connector on the PCI riser-card assembly. Press the edge of the connector firmly into the PCI
riser-card assembly. Make sure that the adapter snaps into the PCI riser-card assembly securely.
Figure 32. Adapter installation in PCI riser-card assembly 1
Step 6. Installing a ServeRAID adapter in PCI riser-card assembly 2:
1. Pull the release pin to unlock the release latch.
2. Rotate the retention latch to the open position.
3. Insert the adapter into the PCI riser-card assembly, aligning the edge connector on the adapter
with the connector on the PCI riser-card assembly. Press the edge of the connector firmly
into the PCI riser-card assembly. Make sure that the adapter snaps into the PCI riser-card
assembly securely.
4. Rotate the retention latch to the close position. Make sure the retention latch engages the
adapter securely; then, push in the release pin to lock the retention latch.
48
Lenovo System x3530 M4 Installation and Service Guide