Table of Contents
Advertisement
Figure 166. Video connector alignment
Step 3.
Connect the video cable to the connector on the system board. Route the cable as shown in the
following illustration. Secure the cable with any cable clips on the chassis.
Step 4.
Reinstall the cover (see "Replacing the server top cover" on page 189).
Step 5.
Reconnect the power cords and any cables that you removed.
Step 6.
Turn on the peripheral devices and the server.
Removing the power interposer card assembly
Use this information to remove the power interposer card assembly.
To remove the power interposer card assembly, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2.
Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Remove the server cover (see "Removing the server top cover" on page 188).
Step 4.
Remove the air baffle (see "Removing the air baffle" on page 192).
Step 5.
If a ServeRAID adapter is installed in PCI riser-card assembly 2, remove PCI riser-card assembly 2
(see "Removing a PCI riser-card assembly" on page 241).
Step 6.
Remove the redundant power supply slightly out of the server to disconnect it from the power
interposer card.
.
Chapter 6
Removing and replacing structural parts
255
Advertisement
Table of Contents
Troubleshooting
