Removing A Simple-Swap Sata Drive - Lenovo x3530 M4 Installation And Service Manual

This configuration consists of one 8x2.5-inch drive backplane and two 8x1.8-inch drive backplanes and
requires six SAS signal cables.
0 1 2 3 4
This configuration consists of three 8x1.8-inch drive backplanes and requires six SAS signal cables. You
can also install the optional simple-swap 2.5-inch SATA drive kit in this configuration.
IDs for hot-swap drives
The drive ID that is assigned to each drive is printed on the front of the server. The following illustrations
show the locations of the IDs of the drives. The ID numbers and the drive bay numbers are the same.
The following illustration shows the drive bay IDs on a 3.5-inch drive server model.
Figure 114. 3.5-inch hot-swap hard disk drive IDs
The following illustration shows the drive bay IDs on a 2.5-inch drive server model.
Figure 115. 2.5-inch hot-swap hard disk drive IDs

Removing a simple-swap SATA drive

Use this information to remove a simple-swap hard disk drive.
To remove a simple-swap SATA drive, complete the following steps:
204
Lenovo System x3530 M4 Installation and Service Guide
5 6 7 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31