Table of Contents
Advertisement
2. Make sure that the disk firmware and RAID controller and backplane firmware are at the latest
level.
3. Check the SAS cable.
4. Replace the hard disk drive.
•
816f000f-2201ffff : The System [ComputerSystemElementName] has detected a POST Error
deassertion. (ABR Status)
This message is for the use case when an implementation has detected that Post Error has deasserted.
May also be shown as 816f000f2201ffff or 0x816f000f2201ffff
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
50
CIM Information
Prefix: PLAT ID: 0185
User Response
No action; information only. Firmware Error : Sys Boot Status :
•
816f0013-1701ffff : System [ComputerSystemElementName] has recovered from a diagnostic
interrupt. (NMI State)
This message is for the use case when an implementation has detected a recovery from a Front Panel
NMI / Diagnostic Interrupt
May also be shown as 816f00131701ffff or 0x816f00131701ffff
Severity
Info
Serviceable
No
Automatically notify support
No
Alert Category
Critical - Other
SNMP Trap ID
50
Appendix A. Integrated Management Module II (IMM2) error messages
549
Advertisement
Table of Contents
Troubleshooting
