Lenovo x3530 M4 Installation And Service Manual page 55

Step 4. Install a 2.5-inch hot-swap drive:
a. Remove the filler panel from the empty drive bay.
b. Make sure that the drive-tray handle is in the open (unlocked) position.
c. Align the drive assembly with the guide rails in the bay.
Figure 24. 2.5-inch hot-swap hard disk drives installation
d. Gently push the drive assembly into the drive bay until the drive stops.
e. Rotate the drive-tray handle to the closed (locked) position.
Step 5. Check the drive status LED to verify that the drive is operating correctly. If the yellow drive status
LED for a drive is lit continuously, that drive is faulty and must be replaced. If the green drive
activity LED is flashing, the drive is being accessed.
Note: If the server is configured for RAID operation using a ServeRAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ServeRAID adapter documentation for
additional information about RAID operation and complete instructions for using the ServeRAID
adapter.
Step 6. If you are installing additional hot-swap drives, do so now.
Step 7. Restart the server. Confirm that it starts correctly and recognizes the newly installed devices, and
make sure that no error LEDs are lit.
Step 8. Complete the additional steps in "Instructions for Business Partners" on page 23.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 73.
IDs for hot-swap drives
The drive ID that is assigned to each drive is printed on the front of the server. The following illustrations
show the locations of the IDs of the drives. The ID numbers and the drive bay numbers are the same.
The following illustration shows the drive bay IDs on a 3.5-inch drive server model.
Figure 25. 3.5-inch hot-swap hard disk drive IDs
The following illustration shows the drive bay IDs on a 2.5-inch drive server model.
.
Chapter 2 Installing optional devices
41