Replacing A Pci Riser-Card Assembly - Lenovo x3530 M4 Installation And Service Manual

Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the server cover (see "Removing the server top cover" on page 188).
Step 4. If an adapter is installed in the PCI riser-card assembly, disconnect any cables that are connected
to the adapter.
Step 5. Grasp the front and rear of the PCI riser-card assembly at the blue touch-points and lift it out of
the PCI riser connector on the system board.
Figure 150. PCI riser-card assembly removal
Step 6. Remove the adapter, if necessary, from the PCI riser-card assembly (see "Removing an adapter"
on page 193).
Step 7. Set the adapter and PCI riser-card assembly aside.
Step 8. If you are instructed to return the PCI riser-card assembly, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Replacing a PCI riser-card assembly

Use this information to install a PCI riser-card assembly.
To replace a PCI riser-card assembly, complete the following steps:
242
Lenovo System x3530 M4 Installation and Service Guide