Step 8.
If you are instructed to return the video connector, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the front video connector
Use this information to replace the front video connector.
To replace the front video connector board, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2.
Align the video connector with the slot on the server and install the two screws to secure it to
the server.
Note: Refer to the illustrations below for 2.5-inch and 3.5-inch hard disk drive bays models
respectively. Depending on your server model, align the video connector from inside or outside
the server.
254
Lenovo System x3530 M4 Installation and Service Guide