Lenovo x3530 M4 Installation And Service Manual page 292

Step 7. Reinstall the DIMMs onto the system board (see "Replacing a memory module" on page 215).
Step 8. Reinstall the microprocessors and heat sinks (see "Replacing a microprocessor and heat sink" on
page 265).
Step 9. Install the socket covers that you removed from the microprocessor sockets on the new system
board and place them on the microprocessor sockets of the old system board, if you have not
done so.
Step 10. Reconnect the SAS signal cables and remote RAID battery cable to the ServeRAID adapter, if
you removed them earlier.
Step 11. Reinstall the PCI riser-card assemblies with the adapters, if any were installed (see "Replacing a
PCI riser-card assembly" on page 74).
Step 12. Reinstall the air baffle (see "Replacing the air baffle" on page 192).
Step 13. Reinstall the cover (see "Replacing the server top cover" on page 189).
Step 14. Reconnect the power cords and any cables that you removed.
Step 15. Turn on the peripheral devices and the server.
Important: Perform the following updates:
• Either update the server with the latest RAID firmware or restore the pre-existing firmware from a diskette
or CD image.
• Update the UUID (see "Updating the Universal Unique Identifier (UUID)" on page 99).
• Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page 101).
• If you purchased a Feature on Demand, make sure that you reactivate the feature using the instructions in
the Feature on Demand documentation.
278
Lenovo System x3530 M4 Installation and Service Guide