This configuration consists of one 8x1.8-inch drive backplane and requires two SAS signal cables. You
can also install the optional simple-swap 2.5-inch SATA drive kit in this configuration.
The following illustrations show the supported combination of drive backplane configurations that you
can use to support 12 drives:
This configuration consists of three 4x2.5-inch drive backplanes and requires three SAS signal cables.
This configuration consists of one 8x2.5-inch drive backplane and one 4x2.5-inch drive backplane
and requires three SAS signal cables.
This configuration consists of one 4x2.5-inch drive backplane and one 8x1.8-inch drive backplane
and requires three SAS signal cables.
0
1
2
3
8 9 10
The following illustrations show the supported combination of drive backplane configurations that you
can use to support 16 drives:
This configuration consists of four 4x2.5-inch drive backplanes and requires four SAS signal cables.
11 12 13 14
15
Empty
Empty
.
Chapter 6
Removing and replacing structural parts
201