Work Limiter - Mercedes-Benz Unimog Operating Instructions Manual

Hydrostatic drive system
204
To activate and adjust current speed/
Ñ
increase set speed
To activate and call up stored speed/
q
reduce set speed
To deactivate working mode cruise con-
o
trol
X
Activation requirements: activate the
hydrostatic drive system (
X
Make sure that "work" mode is selected
( Y page 202).
X To activate working mode cruise con-
trol and store a speed: drive at the
desired speed and briefly press the Ñ
button.
Status indicator ; appears in the on-board
computer. Working mode cruise control is
activated. The speed you are driving at is
saved.
X
Release the accelerator pedal.
In order to maintain the stored speed,
working mode cruise control automatically
brakes or accelerates the vehicle.
X
Release the accelerator pedal.
X
To activate working mode cruise con-
trol at speeds faster or the same as the
stored speed: press the q button
briefly.
X
Release the accelerator pedal.
Status indicator ; appears in the on-board
computer. The vehicle is decelerated to the
stored speed. In order to maintain the
stored speed, working mode cruise control
automatically brakes or accelerates the
vehicle.
X
X
X
X
Y page 199).
Working mode cruise control is deactivated
automatically if:
R
R

Work limiter

The work limiter can be used in conjunction
with working mode cruise control. When you
have activated the work limiter, you have the
possibility of entering a load value for the die-
sel engine. If, during working operation, this
load value is reached while using attached
equipment, a red arrow appears in the status
indicator. The vehicle speed is then reduced
below the stored speed of the working mode
cruise control. The speed of the diesel engine
remains the same, however. This serves to
prevent the mechanical device protection on
your attached equipment from being trig-
gered. The stored speed of the working mode
cruise control and the load value must be
adapted to the corresponding working oper-
ation.
To activate working mode cruise con-
trol at speeds slower than the stored
speed: press the q button briefly.
Status indicator ? appears with a blue
arrow in the on-board computer.
Release the accelerator pedal.
This maintains all speeds ranging from
0 km/h up to the stored speed. The stored
speed will not be exceeded.
In order to maintain the currently stored
speed, working mode cruise control auto-
matically brakes or accelerates the vehicle.
To activate working mode cruise con-
trol with the cruise control lever and to
set speeds: drive with the cruise control
lever ( Y page 205).
To deactivate working mode cruise con-
trol: press the o button briefly.
Status indicator ;, = or ? goes out in
the on-board computer.
you brake sharply
a door is opened