Mercedes-Benz Unimog Operating Instructions Manual page 285

X
Make sure that the quick-change platform
is lowered completely.
The Y indicator lamp in the status area
of the on-board computer must be not be lit
and the ball sockets of the quick-change
platform must rest completely on the balls.
X
Switch off the engine.
X
Remove left and right locking pins = from
pins :.
X
Using the handle, turn left and right pins :
upwards and remove them from rear ball
sockets ;.
X
Pull out locking pin B on catch lever C.
X
Push catch lever C inwards in the direction
of the arrow until it engages in retainer
spring ?.
The lifting cylinder is mechanically decou-
pled from the quick-change platform. The
quick-change platform only rests on the 4
balls of ball sockets ;.
X
Open the rear platform dropside
Y
( page 274).
X
Attach lifting gear C at the front and back
to the D lashing points on the platform
floor.
X
Close the rear platform dropside
( Y page 274).
X
Carefully raise the quick-change platform
horizontally with the lifting gear.
X
Unscrew magnet E from the quick-change
platform.
Tipper platform
Z
283