Settings, Function Button Menu Windows - Mercedes-Benz Unimog Operating Instructions Manual

Menus and input windows in the on-board computer
If hydraulic connections of the same colour
have:
one red mark, then only the hydraulic con-
R
nection with a yellow mark can be control-
led.
two red marks, then both hydraulic con-
R
nections are disabled. The symbols of the
hydraulic connections are then grey.
X
Settings
Call up the
Y
( page 240).
X
Press the r or s button to select the
Limits
entry.
X
Press the 9 button.
Limits
The input window appears.
X
Press the r or s button to select the
desired hydraulic connection.
X
To set a limit: press the u or t
button until yellow mark ? is at the desired
position.
or
X
To disable a hydraulic connection: press
and hold the t button until yellow
mark ? is at the smallest value.
X
Release the t button and press again
until red mark A appears.
X
All: press the 9 button.
The Working functions
closes.
"Settings," "Function button" menu
windows
You can assign a specific function to the blue
button on the control lever. If you then move
the control lever, the red and green hydraulic
connections will be controlled. If no function
has been assigned and you move the control
lever with the blue button pressed, the
hydraulic connections will not be controlled.
menu window
menu window
Structural
sequence in the
on-board com-
puter
Operation and main-
tenance â
Hydraulics
Working func‐
tions
Settings
Function button
X
Settings
Call up the
Y
( page 240).
X
Press the r or s button to select the
Function button
X
Press the 9 button.
Function button
The
appears.
X
Select the desired function with the r
or s button.
Working speed: constant working
R
speed mode is activated/deactivated
( Y page 264).
Equipment function: the equipment
R
can be equipped with an electrical
switching function for the hydraulic con-
nections (see manufacturer's operating
instructions). The electrical switching
function for the hydraulic connections
can be switched on and off. This way,
additional hydraulic connections can be
controlled.
Joystick: if the hydrostatic drive sys-
R
tem has been activated, the vehicle can
Selection
Working speed
Equipment func‐
tion
Joystick
Work Drive
menu window
entry.
selection window
Z
241