Power Take-Off - Mercedes-Benz Unimog Operating Instructions Manual

Transmission-driven power take-off
General notes
The transmission driven power take-off can
be operated:
when the vehicle is stationary
R
when the vehicle is driven forward in 1st to
R
4th gear
when the vehicle is driven in reverse in 1st
R
to 5th gear
The transmission driven power take-off can
also be activated if the working gears
( Y page 182) or the crawler gears
( Y page 184) are engaged.
Engaging/disengaging the transmission-
driven power take-off
! When power take-off is activated, you
must only change gear when the vehicle is
stationary. The transmission may other-
wise be damaged.
X
To engage: ensure that the engine is run-
ning and the vehicle is stationary.
X
Vehicles with Telligent
depress the clutch pedal.
X
Vehicles with Telligent
gearshift: shift the transmission into neu-
tral.
X
All vehicles: press switch :.
Indicator lamp ; in the switch flashes for
several seconds. Engaging the transmis-
sion-driven power take-off occurs after a
few seconds.
If power take-off is engaged, the corre-
sponding display message appears in the
X
X
X
X
Engine-driven power take-off
! Engine-driven power take-off may only be
Engine-driven power take-off is mostly used
for power hydraulics. It can, however, be used
for other attached equipment (e.g. pump
drives).
When automatic regeneration of the diesel
particle filter is carried out, the engine speed
®
gearshift:
is increased.
®
automatic
Equipment operation
event window of the on-board computer for
approximately two seconds.
The I indicator lamp in the status area
of the on-board computer and indicator
lamp ; in the switch light up.
Vehicles with Telligent
shift: the transmission-driven power take-
off turns. With a gear engaged, the trans-
mission-driven power take-off only turns
when the vehicle pulls away.
Vehicles with Telligent
slowly release the clutch pedal and pull
away.
The transmission-driven power take-off
turns.
All vehicles: observe the general notes on
engine speed mode (
Activate constant working speed
( Y page 263).
To disengage: press switch =.
The I indicator lamp in the status area
of the on-board computer and indicator
lamp ; in the switch go out.
activated when the engine is at a standstill.
®
automatic gear-
®
gearshift:
Y page 262).
265