Mercedes-Benz Unimog Operating Instructions Manual page 283

X
Remove screws ? from lifting cylinder B
on the underside of the tipper platform.
X
Replace screws ? with two M12 x 50 mm
set screws.
X
Remove screws A.
X
Raise the tipper platform slightly with the
crane and fold in safety prop C.
X
Turn the key to position 2 in the ignition
lock.
X
Simultaneously lower the tipper platform
with the control lever/switch (
and with the crane, until the tipper platform
is completely resting on the ball sockets.
X
Open the rear platform dropside
( Y page 274).
X
Attach the D lifting gear to rear lashing
points E on the platform floor.
X
Close the rear platform dropside
( Y page 274).
X
Remove left and right locking pins H from
pins F.
X
Using the handle, turn left and right pins F
upwards and remove them from rear ball
sockets G.
X
Using the crane, carefully lift the tipper
platform horizontally and remove it.
Y page 277)
X
Unscrew magnet I from the tipper plat-
form.
X
Attach magnet I to switch J, e.g. with
adhesive tape.
The Y indicator lamp in the status area
of the on-board computer remains off when
the tipper platform has been removed.
X
Make sure that lifting cylinder B has been
fully retracted.
X
Lash lifting cylinder B to the frame.
This helps to prevent damage to the fit-
tings.
Tipper platform
Z
281