Coolant - Mercedes-Benz Unimog Operating Instructions Manual

Unlocking/locking the front flap
Two people are required to remove/replace
the front flap.
Removing the front flap
X
Vehicles with a mowing door: release the
handrail and swing the additional mirror
down ( Y page 72).
X
All vehicles: take the square spanner out
of the tool bag ( Y page 312).
X
Unscrew quick-release fasteners ; on
grab handle :.
X
Unlock fasteners = with the square span-
ner in the direction of arrow ?.
X
Pull front flap up and remove.
Replacing the front flap
X
Attach the front flap.
X
Position quick-release fasteners ; on grab
handle : and screw in slightly.
X
Lock fasteners = with the square spanner
in the direction of arrow A.
X
Tighten quick-release fasteners ; on grab
handle :.
X
Vehicles with a mowing door: swing the
additional mirror up and secure the hand-
rail ( Y page 72).
Coolant level
G
WARNING
The cooling system is pressurised, particu-
larly when the engine is warm. If you open the
cap, you could be scalded if hot coolant
sprays out. There is a risk of injury.
Let the engine cool down before you open the
cap. Wear gloves and eye protection. Open
the cap slowly to release the pressure.
G
WARNING
Service product can be poisonous and haz-
ardous to health. There is a risk of injury.
Observe the instructions on the respective
original container when using, storing and dis-
posing off service products. Always store ser-
vice products in the sealed original container.
Always keep service products out of the reach
of children.
! Do not operate the vehicle if the coolant
level is too low. Otherwise, the engine may
be damaged.
X
Park the vehicle on a level surface.
X
Apply the parking brake.
X
Switch off the engine.
X
Switch the ignition lock to position 0.
X
When checking/topping up the coolant
make sure that you have a secure footing.
Maintenance
Z
293