Mercedes-Benz Unimog Operating Instructions Manual page 208

Hydrostatic drive system
206
Changing direction
X
Make sure that vehicle speed is below
30 km/h.
X
Make sure that working mode cruise con-
trol is switched off.
X
Turn the direction of travel selection switch
to the h (drive/driving forwards) position.
X To preselect reverse driving direction:
press the cruise control lever to the left for
approximately one second A.
A warning tone sounds.
or
X To preselect forward driving direction:
press the cruise control lever to the right for
approximately one second =.
A warning tone sounds.
X
Reduce speed until the vehicle is almost
stationary.
A signal tone sounds; the preselected gear
is selected. The u indicator lamp in the
status area of the on-board computer dis-
play lights up. The on-board computer dis-
play shows the engaged gear.
X
Depress the accelerator pedal.
Switching working mode cruise control
on/off
X To activate working mode cruise con-
trol at speeds faster or the same as the
stored speed: push control lever in the
direction of arrow :.
X
Release the accelerator pedal.
The working mode cruise control status
indicator appears in the on-board computer
( Y page 203). The vehicle is decelerated to
the stored speed. In order to maintain the
stored speed, working mode cruise control
automatically brakes or accelerates the
vehicle.
X To activate working mode cruise con-
trol at speeds slower than the stored
speed: push the cruise control lever in the
direction of arrow :.
The working mode cruise control status
indicator appears in the on-board computer
( Y page 203).
X
Release the accelerator pedal.
This maintains all speeds ranging from
0 km/h up to the stored speed. The stored
speed will not be exceeded.
In order to maintain the currently stored
speed, working mode cruise control auto-
matically brakes or accelerates the vehicle.
X To deactivate working mode cruise con-
trol: push the cruise control lever in the
direction of arrow :.
The working mode cruise control status
indicator in the on-board computer goes
out ( Y page 203).
Setting the speed of working mode
cruise control
X
Activate working mode cruise control.
X
To increase the speed: push the cruise
control lever in direction of travel =/A.
or
X
To decrease the speed: push the cruise
control lever in the opposite direction to
direction of travel =/A.
Refer to the "Working mode cruise control"
section for further information ( Y page 203).