Mercedes-Benz Unimog Operating Instructions Manual page 259

Activating working hydraulics circuit II
X
Press the 9 button on the steering wheel
or the black button on the control lever until
the indicator lamp in button V lights up.
Front working hydraulics circuit II is activa-
ted. The symbol for front working hydraul-
ics circuit II symbol Z is coloured.
Switching front working hydraulics cir-
cuit II back to standby mode
X
Hydraulics
Call up the
( Y page 237).
X
Using the r or s button, select front
working hydraulics circuit II.
X
Press the 9 button on the steering wheel
or the black button on the control lever until
the indicator lamp in button V flashes.
The symbol for front working hydraulics cir-
cuit II Z has a coloured border. Front work-
ing hydraulics circuit II is in standby mode.
Deactivating front working hydraulics cir-
cuit II
X
Press button V.
The indicator lamp in button V goes out.
or
X
Switch off the hydraulic system
( Y page 230).
or
X
Turn the key to position 1 in the ignition
lock.
Activating/deactivating side and rear
working hydraulics system circuit II
! Only switch on the hydraulic system when
it is connected to an item of attached
equipment. There is otherwise a risk of
damage to the hydraulic system.
menu window
Working hydraulics circuit II
Switching side and rear working hydraul-
ics circuit II to standby mode
X
Connect the equipment to the working
hydraulics (see the manufacturer's sepa-
rate operating instructions) (
X
Start the engine.
X
Make sure that the hydraulic system is
switched on ( Y page 230).
X
Press button W.
The indicator lamp in button W flashes.
Hydraulics
The input window opens in the
on-board computer. Side and rear working
hydraulics circuit II line \ is selected. Side
and rear working hydraulics circuit II is in
standby mode.
Selecting an operating mode
X Attached equipment with constant
flow rate: make sure that
257
Y page 230).
LS
is not in the
Z