Menus And Input Windows In The On-Board Computer; Function - Mercedes-Benz Unimog Operating Instructions Manual

Menus and input windows in the on-board computer

Changing the value
X
If necessary, switch the desired hydraulics
circuit to standby mode:
Snow plough load relief (
R
Continuous consumers (
R
Working hydraulics circuit
R
( Y page 244)
Power hydraulics circuit (
R
The corresponding symbol is marked with a
coloured border. The indicator lamp in the
corresponding button flashes.
X
Press the r or s button to select the
desired hydraulic circuit.
X Attached equipment with constant
flow rate: change the value. To do so,
press the u or t button.
or
X
Equipment with load sensing: press and
hold the t button until
the input window.
Activating a hydraulics circuit
X
Press the 9 button on the steering wheel
or the black button on the control lever until
the indicator lamp in the corresponding
button lights up.
The corresponding symbol is coloured.
Switching the hydraulics circuit back to
standby mode
X
Press the r or s button to select an
activated hydraulics circuit.
X
Press the 9 button on the steering wheel
or the black button on the control lever until
the indicator lamp in the corresponding
button flashes.
The symbol has a coloured border.
Deactivating a hydraulics circuit
X
Deactivate the desired hydraulics circuit
using the corresponding button:
Snow plough load relief (
R
Continuous consumers (
R
Y page 248)
Y
page 252)
"Load profile 1" or "Load profile 2"
Y page 258)

function

If you have saved a profile for equipment fit-
ted (
settings again from this profile. The attached
equipment is then immediately ready for use.
Structural
sequence in the
on-board com-
puter
Operation and main-
LS
is shown in
tenance â
Hydraulics
Working func‐
tions
Load profile 1
Load profile 2
X
X
X
Y page 248)
Y page 252)
Working hydraulics circuit
R
( Y page 244)
Power hydraulics circuit (
R
The indicator lamp in the corresponding
button goes out. The symbol is grey.
Y page 242), you can call up the saved
or
Working functions
Call up the
dow ( Y page 236).
Press the r or s button to select the
Load profile 1
or
entry.
Press the 9 button.
The saved profile is loaded and the setting
values applied. The on-board computer
Profile 1 loaded
briefly shows the
Profile 2 loaded
message in the dis-
play.
Y page 258)
Selection
menu win-
Load profile 2
or
Z
239