Notes - Mercedes-Benz Unimog Operating Instructions Manual

Rotating beacons or strobe lights
Switching the rotating beacons or
strobe lights on/off
X
To switch on: press button :.
Indicator lamp ; in the switch lights up.
The À indicator lamp in the status area
of the on-board computer lights up.
X
To switch off: press switch =.
Indicator lamp ; in the switch goes out.
The À indicator lamp in the status area
of the on-board computer goes out.
When operating the vehicle with the rotating
beacons or strobe lights, observe the appli-
cable national regulations for the relevant
country. If the required field of vision is
obscured by trailers, special bodies or other
attachments, make the vehicle safe by using
additional lights.
Adjusting the stand height
! If you extend the stand, always observe
the change in vehicle height, e.g. if you
drive through an underpass or in a multi-
storey car park. The vehicle or building may
be damaged. Lower the stand in good time.
Example: rotating beacon
X
Hold stand :.
X
Loosen wing nut ;.
X
Move stand : to the desired height.
X
Tighten wing nut ;.
Notes on replacing bulbs
G
WARNING
Bulbs, lamps and plug connectors can
become very hot during use. When replacing a
bulb, you could burn yourself on these com-
ponents. There is a risk of injury.
Allow these components to cool down before
replacing the bulb.
G
DANGER
Xenon bulbs are under high voltage. You can
get an electric shock if you remove the cover
of the xenon bulb and touch the electrical
contacts. There is a risk of fatal injury.
Never touch the parts or the electrical con-
tacts of the xenon bulb. Always have work on
the xenon bulbs carried out at a qualified spe-
cialist workshop.
! Make sure bulbs are positioned securely.
if your vehicle is equipped with bi-xenon head-
lamps, the inscription "bi-xenon" is featured
on the headlamp glass.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore ensure
that all bulbs are functioning at all times. The
Lighting system
Z
79