Working Functions Menu Window - Mercedes-Benz Unimog Operating Instructions Manual

Menus and input windows in the on-board computer
236
Hydraulics menu windows, vehicles with position-
ing pump (example)
Symbols for the working hydraulics circuit
:
and power hydraulics circuit
Attached equipment with constant flow
;
rate: flow rate
Equipment with load sensing:
Hydraulic connections
=
Symbols for operating mode display: con-
?
tinuous consumers, proportional control
or snow plough load relief
Hydraulic connections
A
Power hydraulics circuit IV deactivated
B
Power hydraulics circuit III deactivated
C
Side and rear working hydraulics system
D
circuit II activated
Front working hydraulics circuit II in
E
standby mode
Working hydraulics circuit activated
F
X
Using the u or t button, scroll to â
operation and maintenance (
X
Use the r or s button to scroll to the
Hydraulics
Hydraulics
The
operating conditions of the working and
power hydraulics are displayed.
"Working functions" menu window
As a rule, it is simplest to operate the on-
board computer using the buttons on the
steering wheel. You can, however, also call up
Working functions
the
LS
Y page 117).
menu window.
menu window appears. All
menu window using
the control lever and, if necessary, to change
settings as well.
Structural
sequence in the
on-board com-
puter
Operation and main-
tenance â
Hydraulics
Working func‐
tions
display
Operation using the buttons on the steer-
ing wheel
X
Make sure the vehicle is stationary.
X
Using the u or t button, scroll to â
operation and maintenance.
X
Press the r or s button to select the
Hydraulics
Hydraulics
The
X
Press the 9 button.
Working functions
The
X
Press the r or s button to select the
desired entry.
X
Press the 9 button.
The desired input window appears.
Selection
Hydraulics
Load profile 1
Load profile 2
Settings
Back
entry.
menu window appears.
menu appears.