Pulling Away In Equipment Driving Mode - Mercedes-Benz Unimog Operating Instructions Manual

Equipment operation
266
X
To engage: switch off the engine.
X
Turn the key to position 2 in the ignition
lock.
X
Press switch :.
The I indicator lamp in the status area
of the on-board computer and indicator
lamp ; in the switch light up. The engine-
driven power take-off is engaged.
In the event window of the on-board com-
puter, the corresponding display message
appears for approximately two seconds.
X
Start the engine.
X
Observe the general notes on engine speed
mode ( Y page 262).
X
Activate constant working speed
( Y page 263).
X
To disengage: press switch =.
The I indicator lamp in the status area
of the on-board computer and indicator
lamp ; in the switch go out.

Pulling away in equipment driving mode

Vehicles with Telligent
X
To pull away with the selected engine
speed:
with the crawler gears engaged
R
( Y page 184), select a gear
with the working gears engaged
R
( Y page 182), select a gear (one to five)
for vehicles without working gears,
R
select 1st gear
X
Release the parking brake.
X
Pull away.
Vehicles with Telligent
shift
A gear can only be engaged by operating the
multifunctional lever. The accelerator pedal
must not be depressed during the gearshift.
After engaging a gear, you must depress the
accelerator pedal to pull away.
X
To pull away with the selected engine
speed:
®
gearshift
®
automatic gear-
with the crawler gears engaged
R
( Y page 184), select a gear
with the working gears engaged
R
( Y page 182), select a gear (one to five)
for vehicles without working gears,
R
select 1st gear
X
Release the parking brake.
X
Pull away.
If the accelerator pedal is depressed
beyond 50%, the vehicle pulls away even if
the accelerator pedal is released.
Shifting gears in equipment driving
mode
Vehicles with Telligent
Gear changes are only possible when the
clutch pedal is depressed.
X
Select a gear.
X
Depress the clutch pedal. The accelerator
pedal must not be depressed during the
gearshift.
X
Wait for the gear change.
X
Release the clutch pedal.
Vehicles with Telligent
shift
A gear can only be engaged by operating the
multifunctional lever. The accelerator pedal
must not be depressed during the gearshift.
The accelerator pedal must be depressed
again after changing gear.
After the accelerator pedal has been
depressed beyond 50% and the clutch has
engaged, the vehicle will drive on even if the
accelerator pedal is released.
Stopping in equipment driving mode
X
Depress the brake pedal or shift to neutral.
The power take-offs are disengaged.
M
is shown in the on-board computer for
normal engine management.
®
gearshift
®
automatic gear-