Clutch Faulty - Mercedes-Benz Unimog Operating Instructions Manual

Transmission and clutch
Display messages
Ø

Clutch faulty

Ú
Transmission
faulty
0
On-board computer event window
Possible causes/consequences and M Solutions
Supplementary text Û:
centre.
G
WARNING
The transmission no longer changes gear. The reservoir pressure
in the transmission/clutch may be too low.
X
Stop the vehicle as quickly as possible, paying attention to traf-
fic conditions.
X
Apply the parking brake.
X Transmission/clutch reserve pressure too low
If the
event window is displayed: start the engine and let it run until
there is adequate reservoir pressure in the transmission circuit/
clutch circuit.
Transmission/clutch reserve pressure too low
The
event window goes out.
X
Switch off the engine.
X
Start the engine again after approximately ten seconds.
X
theClutch faulty Stop vehicle. Contact service
If
centre.
event window is displayed again: activate backup
drive mode ( Y page 120).
X
If backup drive mode cannot be activated: consult a qualified
specialist workshop.
Supplementary text Û:
only be changed in backup drive mode.
G
WARNING
The transmission gearshift system is malfunctioning.
X
Activate backup drive mode (
X
Move the vehicle to a safe position.
X
Stop the vehicle as quickly as possible, paying attention to traf-
fic conditions.
X
Apply the parking brake.
X
Consult a qualified specialist workshop.
The oil temperature of the torque converter clutch is too high.
X
Shift to a lower gear.
The oil temperature decreases, as soon as the torque converter
clutch engages. The X indicator lamp in the status area of
the on-board computer goes out.
Stop vehicle. Contact service
Park vehicle safely. Gears can
Y page 120).
141
Z