Engine Radiator - Mercedes-Benz Unimog Operating Instructions Manual

Table of Contents

Advertisement

Mowing door wiper blade
X
Apply the parking brake.
X
Shift into neutral.
X
Switch off the engine.
X
Remove the key from the ignition lock.
X
To remove: unscrew nut = on wiper
blade :.
X
Raise wiper arm ;.
X
Remove wiper blade :.
X
Carefully lift wiper arm ; off the wind-
screen.
X
To fit: carefully lift wiper arm ; off the
windscreen.
X
Insert new wiper blade :.
X
Screw on new nut = and tighten.
X
Fold wiper blade : onto the windscreen.
Cleaning the radiator
Important safety notes
G
WARNING
If you clean the radiator, the air conditioning
condenser or the protective grid with the
engine at normal operating temperature, you
can burn yourself on the hot components.
There is a risk of injury.
Allow the engine to cool down before cleaning
the radiator, the air conditioning condenser or
the protective grid. Always wear protective
gloves while doing so.
! Only direct the compressed-air, steam or
water jet towards the radiator surface in a
vertical direction. Ensure that the radiator
fins are not damaged. Remove any dirt from
the radiator fins. Damaged or dirty radiator
fins can cause the engine to overheat. If
there is a loss of coolant or damage to the
cooling and heating system, have it
checked at a qualified specialist workshop.
Depending on the nature of the work per-
formed by your vehicle, the engine radiator
and the charge-air cooler may become heavily
soiled.
Check the engine radiator and charge-air
cooler for soiling on the exterior every time
you refuel.
In extremely dirty conditions, e.g. mowing
operations, check the engine radiator several
times a day and clean it whenever necessary.
X
Check the coolant temperature in the on-
board computer (
Y
Only clean the radiator at a coolant tem-
perature below 50 †.
Further tips on cleaning the engine radi-
i
ator and the charge-air cooler can be found
in the "Tips on maintaining the value of your
vehicle" supplement.
Cleaning the engine radiator and air
conditioning condenser
X
Pull lever ; and swing it to the right.
X
Open protective grid :.
Maintenance
page 125).
Z
301

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents