Mercedes-Benz Unimog Operating Instructions Manual page 286

Tipper platform
284
X
Attach magnet E to switch F, e.g. with
adhesive tape.
The Y indicator lamp in the status area
of the on-board computer remains off when
the quick-change platform has been
removed.
X
Make sure that connection part G for the
quick-change platform is engaged in
retainer springs H.
X
Lash connection part G to the frame.
This helps to prevent damage to the fit-
tings.
Fitting the quick-change platform
A second person is required to fit the quick-
change platform.
X
If the quick-change platform has been
removed, make sure that connection part
G for the quick-change platform has
engaged in spring catches H.
X
Remove magnet E on switch F.
X
Attach lifting gear C at the front and back
to the D lashing points on the platform
floor.
X
Carefully lift the quick-change platform
horizontally using the lifting gear.
Ball sockets ; on the quick-change plat-
form must rest completely on the balls.
X
Press catch lever C outwards in the direc-
tion of the arrow until it engages in retainer
spring A.
X
Secure catch lever C with locking pin B.
X
Insert pins : into the left and right sides of
the rear ball sockets ; and turn the handle
downwards.
X
Place locking pins = onto pins :.
X
Open the rear platform dropside
Y
( page 274).
X
Detach lifting gear C from the D lashing
points on the platform floor.
X
Close the rear platform dropside
( Y page 274).
X
Installation check: raise the quick-change
platform ( Y page 277).
X
Screw magnet E onto the quick-change
platform.
X
Check that the Y indicator lamp in the
status area of the on-board computer is
functioning correctly.
X
Check that locking bolts I between the
quick-change platform and connecting part
are correctly fitted.
X
Lower the quick-change platform
Y
( page 277).