Button - Mercedes-Benz Unimog Operating Instructions Manual

Equipment operation
264
X
To deactivate: press the Ù button repeat-
edly until the
window appears on the on-board com-
puter.
X
Press the
uDeactivate
The working speed can be reset with the
gas pedal.
Activating/deactivating using the control
lever without the blue button
X
To activate and set: make sure that
engine speed mode is activated
( Y page 262).
X
Press the F button upward or down-
ward.
Rotational speed
The
appears in the on-board computer. The
engine speed is increased or decreased
incrementally by approximately 20 rpm up
to the setpoint.
X To set the working speed using the set-
point: press the F button upwards or
downwards until the setpoint has been
reached.
X
Release the F button and press upward
or downward again.
X
To change and save the setpoint: press
the F button upward or downward until
the desired working speed has been
reached.
X
Press the t
wheel.
The setpoint is saved.
X
To deactivate: press the F button
upward or downward.
X
Press the u
steering wheel.
The working speed can be reset with the
accelerator pedal.
Activating/deactivating using the control
lever and with the blue button
X
To activate: make sure that engine speed
mode is activated (
X
To select the working speed function for
the blue button on the control lever, see the
Rotational speed
input

button.

input window
SET
button on the steering
Deactivate
button on the
Y page 262).
"Settings", "Function button" menu window
( Y page 241).
X
Press the blue button on the control lever.
Constant working speed mode is activated.
The working speed is set to the setpoint.
X
To deactivate: press the blue button on
the control lever.
Constant working speed mode is deactiva-
ted. The working speed can be reset with
the gas pedal.
Power take-offs
General notes
Power take-offs are intended for operating
auxiliary equipment. The engine and power
take-offs must be operated at a certain
engine speed/working speed, depending on
conditions of use. Depending on the vehicle
equipment, the working speed can be set with
the accelerator or constant working speed
can be activated.
On vehicles with speed limitation, the preset
engine speed cannot be exceeded when the
PTO is engaged.
For vehicles with additional equipment fitted,
read the equipment manufacturer's operat-
ing instructions before starting operation
with the PTO.
Types of power take-off
There are two types of power take-off: trans-
mission-driven power take-off and engine-
driven power take-off.