Vehicles With Positioning Pump General Notes - Mercedes-Benz Unimog Operating Instructions Manual

Working hydraulics circuit II
256
working hydraulics circuit I is deactiva-
R
ted ( Y page 244)
working hydraulics circuit II is deactiva-
R
ted ( Y page 253)
the continuous consumer has been
R
switched off (
X
Press button K.
The indicator lamp in button K goes out.
The flow rates are again distributed to cir-
cuit I Z and circuit II Z.
Working hydraulics circuit II, vehicles
with positioning pump
General notes
Working hydraulics flow rates, see "Technical
data" ( Y page 374).
Activating/deactivating front working
hydraulics circuit II
! Only switch on the hydraulic system when
it is connected to an item of attached
equipment. There is otherwise a risk of
damage to the hydraulic system.
Y page 252)
Switching front working hydraulics cir-
cuit II to standby mode
X
Connect the equipment to the working
hydraulics (see the manufacturer's sepa-
rate operating instructions) (
X
Start the engine.
X
Make sure that the hydraulic system is
switched on ( Y page 230).
X
Press button V.
The indicator lamp in button V flashes.
Hydraulics
The input window opens in the
on-board computer. Front working hydraul-
ics circuit II line Z is selected. Front work-
ing hydraulics circuit II is in standby mode.
Selecting an operating mode
X Attached equipment with constant
flow rate: make sure that
input window. If necessary, press and hold
the u button until a flow rate is shown.
or
X
Equipment with load sensing: press and
hold the t button until
the input window.
Attached equipment with constant flow
rate, change the flow rate
X
Using the u and t buttons, increase
or decrease the flow rate.
Y page 230).
LS
is not in the
LS
is shown in