Nortel Circuit Card Installation Manual page 866

Page 866 of 906
LD 17 – Serial port configuration parameters.
Prompt Response
REQ: CHG
TYPE: CFN
IOTB YES
ADAN NEW TTY x
NEW PRT x
CDNO 1-16
DENS DDEN
USER xxx
XSM (NO) YES
553-3001-211 Standard 3.00
QPC513 Enhanced Serial Data Interface card
parameters. These parameters must be set for each ports if both ports are
being used.
Description
Change configuration.
Configuration type.
Change input/output devices.
Define a new system terminal (printer) port as device x, where
x = 0 to 15.
Use the ESDI card number to keep track of all ports.
Double density SDI paddle board.
Enter the user of port x. The values that can be entered
depend on the software being used. See the Software Input/
Output: Administration (553-3001-311) for details.
Port is used for the system monitor.
August 2005