Nortel Circuit Card Installation Manual page 691

Software service changes
LD 17 – Prompts to configure the NT8D841Ba paddle board.
Prompt Response
REQ: CHG
TYPE: ADAN
ADAN NEW TTY x
NEW PRT x
CTYPE SDI4
DES XQSDI
USER xxx
XSM (NO) YES
NT8D41BA Quad Serial Data Interface Paddle Board
Once the NT8D841BA QSDI paddle board has been installed in the system,
the system software needs to be configured to recognize it, using the
Configuration Record program LD 17. Instructions for running this program
are found in Software Input/Output: Administration (553-3001-311).
Some of the prompts that are commonly used when running the Configuration
Record program LD 17 are shown in LD 17 – Prompts to configure the
NT8D841Ba paddle board. These parameters must be set for each port if both
ports are being used.
Description
Change configuration
Configuration type
Define a new system terminal (printer) port as device x, where
x = 0 to 15.
Quad port card
Quad density QSDI paddle board.
Enter the user of port x. The values that can be entered
depend on the software being used. See the Software Input/
Output: Administration (553-3001-311) for details.
Port is used for the system monitor.
Circuit Card Description and Installation
Page 691 of 906