NT8D15 E& M Trunk card
Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The NT8D15 E&M trunk card interfaces four analog telephone trunks to the
switch. Each trunk interface connects to a trunk facility using tip and ring
leads that carry voice, ringing, and tone signaling, and to signaling interfaces
by E&M leads. Each unit can be configured independently by software
control in the Trunk Data Block (or Trunk Administration) program LD 14.
You can install this card in any IPE slot.
Note: Up to four analog trunk cards are supported in each MG 1000S
and four analog trunk cards in each MG 1000S Expansion.
Circuit Card
Description and Installation
Page 627 of 906
627
629
631
641
652
655
658
664