System Disabled Actions - Nortel Circuit Card Installation Manual

System disabled actions

These explain the causes of problems and the actions needed to return the card
to an enabled state following system disabling.
SYSTEM DISABLED—NOT RESPONDING
The MSDL card is not installed or is unable to respond to the
Cause:
messages from the system.
:
Action
Check the MSDL messages on the console and take the action
recommended. Refer to Software Input/Output: Administration
(553-3001-311).
Verify that the address switches on the MSDL are set correctly.
Verify that the card is properly installed in the shelf for at least 5
minutes.
If the problem persists, manually disable the card by entering the
DIS MSDL x
MSDL cards" on
SYSTEM DISABLED—SELF-TESTING
The MSDL card has reset itself or the system has reset the card
Cause:
to perform self-tests. Self-tests are in progress.
:
Action
Wait until self-tests are completed. Under some circumstances, the
self-tests may take up to 6 minutes to complete.
Take the action described in the appropriate section below
("SYSTEM DISABLED—SELF-TESTS PASSED" or "SYSTEM
DISABLED—SELF-TESTS FAILED").
SYSTEM DISABLED—SELF-TESTS PASSED
The MSDL card passed self-tests. The system will automatically
Cause:
download the MSDL base code, if needed, and attempt to enable the card
NT6D80 MSDL card
. Follow the steps described in "Previously operating
page 420.
Circuit Card
Page 423 of 906
Description and Installation