Reference clock interface
The recovered clock derived from the facility is available on the MDF
connector. The signals at these connectors conform to the electrical
characteristics of the EIA RS-422 standard.
Switch settings
Various 2MB DTI switch options exist on the NTAK10. These are shown in
Table 236.
Table 236
2 MB DTI switch options
Switch
S1-1
S1-2
S2-1
S2-2
S3-1
S3-2
Note: The ON position for all the switches is toward the bottom of the
card. This is indicated by a white dot printed on the board next to the
bottom left corner of each individual switch.
NTAK10 2.0 Mb DTI card
Off
(Switch Open)
—
CC Enabled
120 ohms
75 ohms
non-French Firmware
—
Circuit Card
Page 733 of 906
On
(Switch Closed)
—
CC Disabled
75 ohms
120 ohms
French Firmware
—
Description and Installation