Nortel Circuit Card Installation Manual page 477

Autodial (A)
The Autodial command allows the user to dial a predefined number stored
within the local system. The DAC will automatically attempt to place a data
call to the Autodial number:
A <CR>
CALLING xxxxxxx
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS
The currently stored Autodial number may be viewed by entering the primary
command D (Display), followed by the selection A (Autodial). See the
Display discussion later in this document.
Note: If the Autodial feature key is not defined in the software you will
be notified by the following: Feature key Autodial not defined.
Speed Call (S)
The Speed Call command allows the user to make a call to a number
associated with a 1-, 2-, or 3-digit access code. The user supplies the access
code, and the DAC places the call according to the code supplied.
S<CR>
ENTER ACCESS CODE: <SP>
xxx<CR>
CALLING yyyyyy
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS
If the DAC does not know the access code length, you will be notified by:
ENTER ACCESS CODE (all digits) <SP>. Leading zeroes must be entered
NT7D16 Data Access card
Circuit Card
Page 477 of 906
Description and Installation