Testing A Trunk Card Using A Maintenance Telephone; Trunk Cards; Procedure; Testing A Trunk Card Using A System Terminal - Nortel Circuit Card Installation Manual

Page 96 of 906 Acceptance tests

Trunk cards

553-3001-211 Standard 3.00
3 End the session in LD 30:
****
Use the following procedures to test a trunk card.

Procedure 8

Testing a trunk card using a maintenance telephone

1 Access the system from a maintenance telephone.
See "Communicating with the Meridian 1" in the Software Input/Output:
Administration (553-3001-311) for details on accessing the system from a
maintenance telephone.
2 Test the trunk unit:
LD 36
TRK l s c u
3 If the maintenance telephone is hooked up to a monitor and the system
response is other than OK, see the Software Input/Output: Administration
(553-3001-311) to analyze the messages.
Procedure 9

Testing a trunk card using a system terminal

1 Log into the system:
LOGI (password)
2 Enter:
LD 36
3 To test a trunk from a remote test center, seize a central office (CO)
monitor trunk:
CALL
or
CALL l s c u
Seize the automatic number identification (ANI) trunk:
TRK l s c u
August 2005
End of Procedure
loop, shelf, card, and unit numbers
End of Procedure
loop, shelf, card, and unit numbers