Nortel Circuit Card Installation Manual page 120

Page 120 of 906
Table 32
NT8D14 vintages BA/BB jumper strap settings—factory standard
Trunk types
CO/FX/WATS
2-way tie (LDR)
2-way tie (OAID)
DID
RAN: continuous
operation mode
Paging
Note: Jumper strap settings J1.X, J2.X, J3.X, and J4.X apply to all eight units; "X" indicates the
unit number, 0–7. "Off" indicates that no jumper strap is installed on a jumper block. Store
unused straps on the universal trunk card by installing them on a single jumper pin as shown
below:
553-3001-211 Standard 3.00
Option settings
Loop length
Zero–1524 m (5000 ft)
Zero–600 ohms
Not applicable: RAN
and paging trunks
should not leave the
building.
Jumper pin
Jumper block
August 2005
Jumper strap settings
J1.X J2.X
Off Off
Jumper strap
553-5924
J3.X J4.X
1–2 1–2