Functional Description - Nortel Circuit Card Installation Manual

Table 234
NTAK10 LED states (Part 2 of 2)
LED State
Flashing
(Green)
Off
Power requirements
Environment

Functional description

Definition
The clock controller is switched on and locking onto the
primary reference.
The clock controller is switched off.
Note: See "Clock controller interface" on
chapter for more on tracking and free-run operation.
The 2MB DTI obtains its power from the backplane. It draws less than 2 A
on +5 V, 50 mA on +15 V and 50 mA on –15 V.
The NTAK10 card meets all applicable Nortel operating specifications.
The NTAK10 provides the following features and functions:
• a clock controller that can be switched in as an option
• software-selectable A/µlaw operation
• software-selectable digital pads on a per channel basis
• frame alignment and multiframe alignment detection
• frame and multiframe pattern generation
• CRC-4 transmission and reception (software selectable)
• card status and alarm indication with faceplate-mounted LEDs
• Periodic Pulse Metering (PPM) counting
• outpulsing of digits on any of the ABCD bits
• Card-LAN for maintenance communication
NTAK10 2.0 Mb DTI card
Circuit Card Description and Installation
Page 723 of 906
page 729 in this