Nortel Circuit Card Installation Manual page 62

Page 62 of 906 Overview
Figure 10
IPE trunk cards installed in an NT8D37 IPE module
PE Module
PE Pwr Sup
553-3001-211 Standard 3.00
IPE
Intelligent line cards
Intelligent trunk cards
0 1
Rng Gen
3 Install the cable that connects the backplane connector on the IPE
module to the module I/O panel.
4 Connect a 25-pair cable from the module I/O panel connector to the Main
Distribution Frame (MDF).
5 Connect the trunk card output to the selected terminal equipment at the
MDF.
6 Configure the individual trunk interface unit using the Trunk
Administration program (LD 14) and the Trunk Route Administration
program (LD 16).
Once these steps have been completed, the trunk card is ready for use.
August 2005
BRSC
2 3 4 5 6 7 Cont
Intelligent line cards
Intelligent trunk cards
BRSC
8 9 10 11 12 13 14 15
Intelligent Superloop
Peripheral Equipment
Shelf
553-6321