Nortel Circuit Card Installation Manual page 298

Page 298 of 906
Figure 51
Set Mode (S M): Table screen
LEI:>S M
1) Default
2) Table
Hit <CR> to accept current value or type in a new one.
Current Mode : 1
Signaling Bits set to Table.
Incoming and outgoing calls are in reference to the CPE.
All ABCD bits are with respect to SENDing from LEI/M1 to CPE
or RECEIVing from CPE to LEI/M1.
Please enter new ABCD bits or hit <CR> to accept.
enter 2 or 4 values.
B bits will be copied to the C and D bits.
IDLE SEND:
IDLE SEND bits changed to: 0101
IDLE RECEIVE:
IDLE RECEIVE bits unchanged.
BLOCKING RECEIVE enabled? (Y/N): N
BLOCKING RECEIVE is disabled.
Incoming call RINGER-ON SEND:
Incoming call RINGER-ON SEND bits not changed.
Incoming call RINGER-OFF SEND:
Incoming call RINGER-OFF SEND bits not changed.
Incoming call OFFHOOK RECEIVE:
Incoming call OFFHOOK RECEIVE bits not changed.
Incoming call CONNECTED SEND:
Incoming call CONNECTED SEND bits not changed.
Incoming call (Far End) DISCONNECT SEND:
Incoming call (Far End) DISCONNECT SEND bits not changed.
Incoming call (CPE) DISCONNECT RECEIVE:
Incoming call (CPE) DISCONNECT RECEIVE not changed.
553-3001-211 Standard 3.00
NT5D33 and NT5D34 Lineside E1 Interface cards
New Mode : 2
If only 2 values are entered, the A and
Current: 0000
Current: 0101
unable to accept new calls. Set this value to N if this state is not needed. If this
value is not set to N, then dip switch #2 position 6 will determine whether
off-hook or on-hook is sent to the M1/SL100 when this state is entered. See
Table 99 on page 270.
August 2005
New: 0101
New:
Current: 0000
Current: 0101
Current: 1111
Current: 0101
You may
New:
New: 0101
New: 11
New:
Current: 1111
Current: 0101
New:
New: