Configuration - Nortel Circuit Card Installation Manual

Configuration

Jumper and switch settings
Software service changes
NT8D02 and NTDK16 Digital Line cards
This section outlines the procedures for configuring the switches and jumpers
on the NT8D02 Digital Line card and configuring the system software to
properly recognize the card. Figure 107 on
switches and jumper blocks are located on this board.
The NT8D02 Digital Line card has no user-configurable jumpers or switches.
The card derives its address from its position in the backplane and reports that
information back to the Call Server through the LAN Link interface.
Voice and data ports are configured using the Meridian Digital Telephone
Administration program LD 11. See the Software Input/Output:
Administration (553-3001-311) for LD 11 service change instructions.
page 542 shows where the
Circuit Card Description and Installation
Page 541 of 906