Standard 3.00 August - Nortel Circuit Card Installation Manual

Page 476 of 906
Primary commands
553-3001-211 Standard 3.00
NT7D16 Data Access card
Whenever a Primary command is expected, the user may enter the Parity
command (period). If Auto Parity has already been done, the Invalid
Command menu is presented:
Invalid Command/Entry
Re-Enter: <SP>
The user's port may be set to idle by entering CTRL Z. Any call in progress
will be dropped, and any Ring Again placed will be released. Once the
Primary Command menu has appeared, the user must enter C to place a call.
The DAC will not accept a number in place of a Primary command.
Once the Primary menu has appeared, only primary commands are accepted.
Call (C)
The Call command must be used to place a call once the Primary menu has
appeared. The DAC will not accept a number only.
C<CR>
ENTER NUMBER:<SP>
xxxxxxx<CR>
CALLING xxxxxxx
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS
August 2005