Nortel Circuit Card Installation Manual page 289

Table 105
MMI commands and command sets (Part 2 of 2)
Command
D S(P)
H or ?
L
Lxx
Q
S A
S C
S D
S M
S S
S T
T
NT5D33 and NT5D34 Lineside E1 Interface cards
Description
Display Status. Displays carrier status, including alarm state and, if
active, alarm level. (Momentarily stop the scrolling display by typing P.
Continue scrolling by typing any other key.)
Help. Displays the Help screen.
Login. Logs into the MMI terminal in a single-LEI system.
Login. Logs into the MMI terminal in a daisy-chained system, where xx
represents the address of the card to be configured.
Quit. Logs out of the MMI terminal.
Note: If it is a daisy-chained system, be certain to log out when
finished with configuration. In a daisy-chained system, only one card
may occupy the bus at a given time and all other LEIs will be unable to
notify the MMI of alarms unless logged-out of configuration mode.
Set Alarm. Sets alarm parameters, such as the allowable bit-errors per
second, threshold, and alarm duration.
Set Clearing. Sets the alarm self-clearing function, "enable" or
"disable."
Set Date. Sets the date or verifies the current date.
Set Mode. Sets the A/B Bits mode.
Set Simple. Sets whether or not the LEI waits for the terminal
equipment to return an idle-state message before returning the channel
to idle at call disconnect from the far-end.
Set Time. Sets the time or verifies current time.
Test. Initiates the E1 carrier test function. To terminate a test
in-process, enter the STOP TEST command at any time.
Circuit Card Description and Installation
Page 289 of 906