Service And Repairs; Headlights - Toro Multi Pro 5800 Service Manual

Service and Repairs

NOTE: See the Kubota Workshop Manual (05--E3B
Series) for engine electrical component repair informa-
tion.

Headlights

CAUTION
The headlights use a halogen bulb that becomes
extremely hot when in operation. Handling a hot
headlight bulb can cause severe burns and per-
sonal injury. Allow enough time for bulb to cool
before handling.
CAUTION
Any surface contamination can damage the
headlight bulb and lead to its failure. Headlight
bulbs should be handled without touching the
clear bulb surface. Handle the bulb by holding
onto the base.
Headlight Disassembly (Fig. 46)
1. Park machine on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
2. Gain access to headlight assembly under dash pan-
el on rear of hood.
3. Unplug wire harness connector from headlight bulb.
4. If bulb removal is necessary, loosen the bulb from the
headlight by rotating it 1/4 turn counter--clockwise.
Then, grasp bulb base and remove bulb from the head-
light.
5. If necessary, remove headlight from machine.
A. Remove three (3) clips that secure headlight to
headlight brackets on rear of hood.
B. Remove headlight from machine.
Multi Pro 5800
Headlight Assembly (Fig. 46)
1. If headlight was removed, secure headlight to ma-
chine:
A. Insert headlight into hood opening. Make sure
that SPEAKER logo on headlight lens is at bottom.
B. Secure headlight to headlight brackets on rear of
hood with three (3) clips.
2. If bulb was removed from headlight, align tabs on
bulb with notches in headlight opening. Insert bulb into
back of headlight without touching the clear bulb sur-
face. Secure bulb to headlight by rotating it 1/4 turn
clockwise.
3. After repairs are completed, attach wire harness
connector to headlight bulb.
2
4
5
1
3
1. Headlight assembly
2. Hood
3. Clip (3 used)
Page 5 - - 31
1
Figure 46
4. Headlight bracket
5. Pop rivet (2 per bracket)
Electrical System