GMC Chevrolet Camaro 1998 Service Manual page 514

8-272 Entertainment
Tune Knob
Lightly press this knob in order to extend the knob.
Rotate the knob in order to choose the desired radio
station. Press the knob back into the stored position
when not in use.
RECALL
Press this button in order to recall station currently
being played or the clock display. Press this button
when the ignition is OFF in order to display the time.
SEEK
Press this button (right or left arrows), in order to tune
to the next higher or the next lower station. The
sound will mute while seeking.
SCAN
Press and hold one of the SEEK buttons for
2 seconds. SCAN will appear on the display. Use
SCAN in order to listen to stations for a few seconds.
The radio will go to a station, stop for a few seconds,
and then continue to the next station. Press SEEK
again to stop scanning. The sound will mute
while scanning. If a preset station has a weak
reception, it will not stop.
PSCAN
Press this button in order to listen to each of the
preset stations for a few seconds. The radio will scan
through each of the stations stored, except those
stations with weak reception. The AUTO TONE setting
stored with that station also will be chosen. Press
PSCAN or one of the stations again to stop scanning.
PSCAN will be displayed whenever the tuner is in
the PSCAN mode. The station number will appear
momentarily just before the frequency is displayed. In
FM mode, this function will scan through both FM1
and FM2 presets, FM1 and FM2 will appear on
the display.
scv
The audio system has a feature called speed
compensated volume (SCV). With SCV, the audio
system adjusts automatically to make up for road and
wind noise. Set the volume at the desired level.
Turn the control ring behind the upper knob clockwise
to adjust the SCV. SCV automatically increases the
volume, as necessary, to overcome noise at any
particular speed. The volume level should always
sound the same as the vehicle is driven. If SCV is not
wanted, rotate the control all the way down. Each
notch on the control ring allows for more volume
compensation at faster vehicle speeds.
Body and Accessories
AUTO TONE
The audio system has a feature called auto tone.
Press the AUTO TONE button in order to choose a
preset treble and bass equalization setting.
AUTO TONE was designed.for the following station
formats:
• Country and western music
• Classical music
• News
• Rock and pop music
• Jazz music
C/W (Country Western) will appear on the display
when you first press AUTO TONE. Each time
its pressed another setting will appear on the displc1,y.
Press it again after JAZZ appears and the AUTO
TONE display wil1 go blank. '
When the TREB and BASS knobs are used, control
will return to them and the AUTO TONE display will go
blank. Use PUSH BUTTONS and AUTO TONE ..
button to program AUTO TONE for station presets.
Bass
Lightly press the BASS knob in order to extend the
knob. Rotate the knob clockwise in order to increase
the bass. Rotate the knob counterclockwise in
order to decrease the bass. When this knob is used;
the radio's AUTO TONE setting will switch to
manual and the AUTO TONE display will go blank.
Treble
Lightly press the TREB knob in order to release the
knob. Rotate the knob clockwise in order to increase
the treble. Rotate the knob counterclockwise in
order to decrease the treble. If a station is too weak or
noisy, turn the TREB knob down. When this knob is
used, the radio's AUTO TONE setting will switch
to manual and the AUTO TONE display will go blank.
Push these knobs back into their stored positions
when you're not using them.
Clock
Press and hold the HR (hour) button until the correct
hour appears on the radio display. Press lind hold
the MIN (minute) button until the correct min~te
appears. There will be a 2 second delay before the
clock goes into the time set mode, and the colon
on the display will blink while in this mode.
(
(
(