GMC Chevrolet Camaro 1998 Service Manual page 879

\
Body and Accessories
2
1
. 296590
Important: The vehicle is equipped with a Set To Get
Cruise feature. This requires the operator to use
the SET/COAST button before the RESUME/ACCEL
slider switch will activate.
The OFF-ON-R/A switch (2) has the following
3 positions:
1 . The OFF position
2. The ON position
3. The Resume Acceleration (R/A) position
When the R/A switch is held in for more than 1 second,
the system starts the acceleration mode and
accelerates the vehicle.
1. Hold in the switch until. the desired speed is
reached.
2. Release the switch. The vehicle will maintain the
selected speed.
For operation of the acceleration mode, ensure that
the following 2 requirements are met:
1. Turn the OFF-ON-R/A switch ON.
2. The vehicle is above the minimum speed limit of
40 km/h (25 mph) with a set speed already in
memory. · ·
The OFF-ON-RIA switch is used in order to
incrementally raise the vehicle speed.
Follow these procedures in order to utilize this
function:
1. Engage the cruise control system.
2. Quickly press the OFF-ON-R/A switch (2) towards
the R/A position.
3. Quickly release the OFF-ON-R/A switch (2).
4. Tap the OFF-ON-R/A switch (2) in order to
increase the speed by 1.6 km/h (1 mph).
5. Do not hold the OFF-ON-R/A switch (2) in the R/A
position, the system will engage the
accelerator mode.
Cruise Control 8-637
Set/Coast Button Switch
3
2
1
296590
The cruise control SET/COAST button switch (3) is
located in the end of the turn signal multifunction lever.
The cruise control SET/COAST button switch (3)
has the following 2 positions:
• NORMAL
• DEPRESSED
Perform the following steps in order to set the
cruise speed:
1. Press the SET/COAST button switch (3) when
you have reached the desired speed.
2. Release the SET/COAST button switch (3).
Set Position
Ensure that the following conditions are met:
• The OFF-ON-R/A switch (2) is ON.
• The vehicle exceeds the minimum speed limit of
40 km/h (25 mph).
The system will cruise within 1.6 km/h (1 mph) of the
actual selected speed.
The system will cruise until one of the following
actions occur:
• The OFF-ON-R/A switch (2) is turned to the OFF
position.
• The ignition switch is turned OFF.
• The SET/COAST button switch (3) is fully pushed
in and held in.
Pressing the brake pedal will cause the SET/COAST
button switch (3) to release. This does not.release
the resume capability.