Evaporator Tube Replacement - GMC Chevrolet Camaro 1998 Service Manual

)
HVAC
Evaporator Tube Replacement
Removal Procedure
1. Recover the refrigerant. Refer to Refrigerant
Recovery and Recharging.
2. Disconnect the electrical connector at the
AJC
refrigerant pressure sensor.
3. Remove the
AJC
evaporator tube bolt at the
module.
4. Remove the A/C evaporator tube bolt at the
condenser.
5. Remove the A/C .evaporator tu.be from the vehicle.
6. Discard the 0-rings.
7. Remove the orifice and the pressure sensor;
if replacing the tu.be.
Installation Procedure
Lightly coat the 0-rings with a mineral .base
525 viscosity refrigerant oil.
1. Install the orifice and the pressure sensor,
if replacing the tube.
2. Install new 0-rings.
3. Install the A/C evaporator tube to the vehicle.
Notice: Refer to Fastener Notice in Cautions
and Notices.
4. Install the A/C evaporator tube bolt at the
condenser.
Tighten
Tighten the A/C evaporator tube bolt at the
condenser to 16 N-m (12 lb ft).
5. Install the A/C evaporator tube bolt at the module.
Tighten
Tighten the A/C evaporator tube bolt at the
module to 16 N-m (12 lb ft).
HVAC System .. Manual 1 ·81
282947
282946
282946