Power Antenna Motor Replacement - GMC Chevrolet Camaro 1998 Service Manual

Body and Accessories
Installation Procedure
1. Insert the plastic cable into the housing. You will
feel resistance after inserting about 30 cm (12 in)
of the cable. Stop inserting the cable when
you feel resistance.
2. Turn the radio OFF.
Ensure that .the plastic cable retracts into the
housing and catches onto the gear mechanism of
the drum housing. ·
If the cable does not retract into the housing,
rotate the cable until the cable rotates into
the housing with the motor operating.
3. Install the contact spring onto the
antenna mast (3).
Ensure that the flanged end of the contact ·
spring (2) faces upward.
4. Inspect the antenna operationby turning the radio
On and OFF several times.
The antenna mast may only extend or retract
halfway.
5. Continue to operate the antenna until the antenna
mast (3) fully extends and retracts.
Power Antenna Motor Replacement
Removal Procedure
1. Remove the quarter inner rear trim finishing panel.
2. Remove the spare tire and jack.
3. Disconnect the antenna cable (4) from the power
antenna.
4. Disconnect the power antenna electrical
connector (3).
5. Remove the drain tube (1) from the grommet in
the rear quarter panel.
6. Remove the power antenna bracket bolt (2).
7. Pull down the bracket. Disengage the power
antenna from the antenna bezel.
8. Remove the power antenna.
9. Unsnap the bezel from the rear quarter panel.
10. Remove the antenna bezel.
Entertainment 8-255
1 ~
296689
3
~ 1
296688
4
296687