GMC Chevrolet Camaro 1998 Service Manual page 356

8-114 lighting Systems
294735
---
294733
Body and Accessories
Installation Procedure
1 . Install the headlamp opening door actuator control
module to the forward lamp harness bracket.
2. Slide the module into the bracket until module (
locks into place.
3. Connect the headlamp opening door actuator
control module electrical connectors.
4. Connect the negative battery cable. Refer
fo
Battery Negative Cable· Disconnect/Connect··.··.
Procedure
in Engine Electrical.
Headlamp Aiming (Screen Method)
Aiming By Screen Method
• To correct the horizontal aim use the adjusting
screw located on the outer side of the headlamps.
• To correct the vertical aim by use the adjusting
screw located in the top center of the headlamps.
• Use a specific aiming area in a darkened location.
Ensure that the aiming area meets the followings:
- The area used must accommodate the
vehicle with a space of 7.6 m (25 ft) left over.
- Measure the additional 7.6 m (25 ft) from the
face of the headlamps to the front of the
screen.
- The floor that the vehicle rests on is level
with the bottom of the screen.
- If the floor is not level, then compensate for
the unlevel floor.
(