GMC Chevrolet Camaro 1998 Service Manual page 153

)
HVAC
7. Install the negative battery cable to the stud.
8. Install the negative battery cable nut to the engine
block stud.
Tighten
Tighten the negative battery cable nut to the
engine block stud to 25 N-m (18 lb ft).
9. Connect the electrical connector at the
A/C compressor.
10. Install the serpentine drive belt. Refer to Drive
Belt Replacement in Engine Mechanical.
11. Charge the A/C system. Refer to Refrigerant
Recovery and Recharging.
12. Perform a leak test on the A/C system. Refer to
Leak Testing.
Compressor Replacement (5.7L)
Removal Procedure
Important: Compressor related noise is generally
A/C system related and not always the compressor
itself. Prior to replacing the compressor, refer to
Noise Diagnosis.
1. Recover the refrigerant. Refer to Refrigerant
Recovery and Recharging.
2. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
3. Remove the serpentine drive belt. Refer to Drive
Belt Replacement (AIC) in Engine Mechanical.
4. Remove the A/C compressor and condenser
hose bolt.
5. Discard the 0-ring.
HVAC System - Manual 1-43
43679
365420
365448