Washers Inoperative - GMC Chevrolet Camaro 1998 Service Manual

Body and Accessories
Wipers/Washer Systems 8-173
Washers Inoperative
Step Action Value(s) Yes No
)
Was the Wiper/Washer System Check performed?
Go to
1 -
Wiper/Washer
Go to Step 2 System Check
2
Check the washer solvent container fluid level.
-
Is the washer solvent container filled? Go to Step 3 Go to Step 4
Fill the washer solvent container.
Go to
3
Is the washer solvent container filled?
-
Wiper/Washer
-
System Check
Check the hoses to ensure that they are correctly attached
4
and that they are not pinched or kinked. -
Are the hoses OK?
Go to Step 6
Go to Step 5
Repair the hoses.
Go to
5
Are the hoses repaired?
-
Wiper/Washer
-
System Check
6
Check for clogged windshield washer nozzles.
-
Are the nozzles clogged? Go to Step 7 Go to Step 8
Replace the clogged nozzles. Go to
7
Are the nozzles replaced?
-
Wiper/Washer
-
System Check
8
Check WIPER/WASH fuse 14 in the IP Fuse Block.
-
Is the fuse open?
Go to Step 9
Go to Step 10
Replace the open fuse.
Go to
9
Is the replacement complete?
-
Wiper/Washer
-
System Check
1. Disconnect the washer pump connector.
2. Turn the ignition switch to ON.
3. Connect a test light between terminals A and B of
10
washer pump connector (harness side).
-
4. Activate the washer switch while observing the
test light.
Is the test light on? Go to Step 11 Go to Step 14
Check for a poor connection at the washer pump
11
connector.
-
Is a poor connection present? Go to Step 12 Go to Step 13
Repair the poor connection.
Go to
12
Is the repair complete?
- Wiper/Washer -
System Check
Replace the washer pump. Refer to Washer Pump
Go to
13
Replacement.
-
Wiper/Washer
-
Is the replacement complete? System Check
1. Connect the test light between the washer pump
14
connector (harness side) terminal A and ground.
-
2. Activate the washer switch while observing test light.
Is the test light on? Go to Step 15 Go to Step 16
Repair the poor connection or open in CKT 150. Go to
15
Is the repair complete?
-
Wiper/Washer -
System Check
1. Backprobe wiper/washer switch connector C215,
16
terminal H, to ground with a test light.
-
2. Activate the washer switch.
Is the test light on? Go to Step 17 Go to Step 19
)