GMC Chevrolet Camaro 1998 Service Manual page 171

)
HVAC
8. Place a feeler gage between the clutch plate and
the clutch rotor,
Important: Make sure that the air gap is even all
around the clutch plate and hub assembly.
9.
Tighten the hex portion of the J 33013-8 until the
air gap between the clutch plate and clutch rotor
is 0.40 mm (0.015 in).
10. Remove the J33013-B.
11 . Hold the clutch plate and hub assembly (2) with
the J 33027-A.
12. Install the compressor shaft nut.
Tighten
Tighten the compressor shaft nut to
17.5 N-m (13 lb ft).
13. Spin the pulley rotor by hand to make sure the
rotor is not rubbing against the clutch drive plate.
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.
Clutch Rotor and/or Bearing Install
(VS -
Conventional Mount)
Tools Required
• J 6083 Snap Ring Pliers
• J 8092 Driver Handle
• J 8433-1 Puller Bar
• J
8433-3 Forcing Screw
• J 9481-A Bearing Installer
• J
21352-A Support Block
• J 33017 Pulley And Bearing Assembly Installer
• J
33019 Bearing Staking Tool
• J 33023-A Puller Pilot
• J
34992 Compressor Holding Fixture
Notice: Do not support the rotor by resting the pulley
rim on a flat surface during the bearing installation
or the rotor face will be bent.
1. Place the pulley rotor on the J 21352-A in order to
fully support the rotor hub during the bearing
installation.
HVAC System - Manual
1 ~s1
187363
J
41790
157218
210146