Fog Lamp Indicator Inoperative (Europe); Hazard Lamps Inoperative - GMC Chevrolet Camaro 1998 Service Manual

8-86 Lighting Systems Body and Accessories
Fog Lamp Indicator Inoperative (Domestic) (cont'd)
Step Action Value(s) Yes No
8
Repair a poor connection or open in circuit 8.
-
-
ls the repair complete?
Go to Step 10
(
9
Repair the poor connection or open in circuit 11.
-
-
ls the repair complete?
Go to Step 10
1. Turn the ignition switch to the OFF position.
10
2. Reconnect all connectors/components removed.
-
Go to Fog Lights
-
Have all the repairs been made?
System Check
Fog Lamp Indicator Inoperative (Europe)
Step Action Value(s) Yes No
1
Was the entire Fog Lights System Check performed?
-
Go to Fog Lights
Go to Step 2 System Check
1. Turn the headlamp switch to the HEAD position.
2. Turn the headlamp dimmer switch to the LOW
position.
2
3. Turn the fog lamp switch to the ON position.
-
4. Using a test light, backprobe the fog lamp switch
harness connector terminal A and ground.
Does the test light illuminate? Go to Step 3 Go to Step 4
Replace the fog lamp switch. Refer to Fog Lamp Switch
3
Replacement - Front (Front) Fog Lamp Switch
- -
Replacement - Front (Front Pontiac)
ls the repair compete?
Go to Step 5
4
Repair a poor connector or open in circuit 122.
-
-
Is the repair compete?
Go to Step 5
1. Turn the ignition switch to the OFF position.
5
2. Reconnect all components/connectors removed.
-
Go to Fog Lights
-
Have all the repairs been made? System Check
Hazard Lamps Inoperative
Step Action Value(s) Yes No
Was the entire Exterior Lights System Check performed? Go to Exterior
1
-
Lights
Go to Step2 System Check
1. Connect a test light between C216 terminal K and
2
ground.
-
2. Turn the hazard switch on.
Does the test light flash off and on? Go to Step 3 Go to Step 4
Replace the turn/hazard switch assembly. Refer to Hazard
3
Warning Switch Replacement - On Vehicle.
-
-
Is the repair complete? Go to Step 9
Connect a test light between the hazard lamp flasher
4
terminal B and ground.
-
Does the test light flash off and on? Go to Step 5 Go to Step 6
5
Repair a poor connection or open in CKT 27.
- -
Is the repair complete? Go to Step 9
Connect a test light between the hazard lamp flasher
6
terminal A and ground.
-
Does the test light flash off and on? Go to Step 7 Go to Step 8
Replace the hazard lamp flasher. Refer to Hazard Lamp
(
7
Flasher Replacement.
- -
ls the repair complete?
Go to Step 9